Canon LV-7292S User Manual page 66

Appendix
No image
The color is strange.
Some displays are not seen
during the operation.
Auto PC adjustment function
does not work.
The setting does not remain
after turning off power.
Power management mode
does not work.
Capture function does – Check the connection and the input signal to see if there is
not work.
Auto setup does not
work properly.
The image is distorted or
runs off.
PIN code dialog box appears
at start-up. numbers you have set). See pages 22, 55-56.
66
– Check the connection between your computer or video
equipment and the projector. See pages 17-19.
– See if the input signal is correctly output from your computer.
Some laptop computers may need to change the setting for
monitor output when connecting to a projector. See your
computer's instruction manual for the setting.
– It takes about 30 seconds to display an image after turning on
the projector. See page 21.
– Check the Input signal, color system, video system or computer
system mode.
– Make sure the temperature is not out of the specified Operating
Temperature (41˚F–95˚F [5˚C–35˚C]).
– When Blank is operating, the image cannot be displayed.
Press the BLANK button or any other button on the
remote control unit.
– Check the Input signal, color system,video system or computer
system mode.
– Make sure the Blackboard is not selected on Image select
menu. See pages 34,41.
– Check the Display function. See page 48.
– Check the Input signal. Auto PC adjustment function can not
work when 480p, 575p, 720p, 480i, 575i, 1035i or 1080i is
selected. See page 30.
– Make sure you selected Store after adjusting setting. Some
settings can not be stored if not registered with Store. See
pages 35,43.
– Power management mode function can not work while Freeze
or BLANK function is running. See page 51.
signal.
– Make sure Off is not selected at any function of Auto setup.
See page 47.
– Check PC adjust menu or Aspect menu and adjust them.
See pages 32-33, 37.
– PIN code lock is being set. Enter a PIN code (the "1234" or