Advertisement
5 PORT DETAIL INSTALLATION PROCEDURE
STEP 6 - TESTING THE PAIRING AND SENSOR CONNECTION
For testing the pairing and sensor connection, please
unplug one of the USB connectors of the charging &
security cables from the USB port. If the alarm is triggered,
it means successful connection. Otherwise, please check
the connection and rework the chapter "Step 3.
Connecting the charging & security cable" of this
installation instruction manual .
Push the alarm off button (①) of the remote control to
turn off the alarm, and push the LED off button (②) to stop
the blinking of the LED light of the charging & security
cables' security sensors.
Alarm off button icon:
LED off button icon:
To remove the current pairing setting, turn on the pairing
reset switch, and turn off the pairing setup switch. After
turning on the pairing reset switch, the remote control will
not work. To make the remote control work again, execute
the pairing process on "Step 5. Setting-up the pairing with
remote control" page of this installation instruction manual.
Advertisement
