Table of Contents
Advertisement
3. Set the WPA2 Preauthentication to Enabled if you want to use this function.
4. The Network Re-auth Interval is 36000 seconds by default, you can setup this
value according to your network environment.
5. Set up RADIUS server inforamtion by inputting WPA Group Rekey Interval,
RADIUS server IP address, RADIUS port and RADIUS Key.
6. Set up WPA encryption methods. If there are only WPA2 clients within your network,
select AES, if WPA clients only, select TKIP; if both exist, select TKIP+AES.
7. You can also enable WEP client to access your wireless network. To enable WEP
clients, set WEP Encryption to Enabled. Select 64-bit or 128-bit Encryption
Strength for key length then click Set Encryptioin Keys button to setup the keys.
Refer to Open mode Step 4 for key configuration.
8. Press Save/Apply to save and activate the settings.
WPA-PSK
1. Click Wireless -> Security in the left side menu to open the configuration page.
2. Select WPA-PSK in the Network Authentication field.
3. Input the WPA Pre-Shared Key. The key is masked by system. To check the key,
press Save/Apply and wait until the page refreshes. Then click Click here to
display link, you can see the key displayed in a seperate window.
4. Setup the WPA Group Rekey Interval.
5. Set up WPA encryption methods. If there are only WPA2 clients within your network,
select AES, if WPA clients only, select TKIP; if both exist, select TKIP+AES.
6. You can also enable WEP client to access your wireless network. To enable WEP
clients, set WEP Encryption to Enabled. Select 64-bit or 128-bit Encryption
Strength for key length then click Set Encryption Keys button to setup the keys.
Refer to Open mode Step 4 for key configuration.
7. Press Save/Apply to save and activate the settings.
DSL-N13 Wireless ADSL 2/2+ Modem Router User Manual
25
Advertisement
Table of Contents
