Selecting The Brightness; Setting The Rear Output And Subwoofer Controller - Pioneer KEH-P7025 Operation Manual

Section
Initial Settings
07

Selecting the brightness

You can select the display brightness. Initially
this mode is set to 12.
1 Press
FUNCTION
Press
FUNCTION
appears in the display.
2 Select the desired brightness with 2/3.
• The display shows
Setting the rear output and sub-
woofer controller
This product's rear output (rear speaker leads
output and RCA rear output) can be used for
full-range speaker (
( ) connection. If you switch rear
Rear SP:S.W
output setting to the
nect a rear speaker lead directly to a subwoofer
without using an auxiliary amp.
Initially, the unit is set for rear full-range speaker
connection (
Rear SP:FULL
When rear output are connected to full range
speakers (when
can connect the RCA subwoofer output to a
subwoofer. In this case, you can select whether
to use the subwoofer controller's (low pass
filter, phase) built-in
auxiliary
S.W Control:EXT
32
En
to select .
BRIGHT
repeatedly until
Brightness
– .
0 15
) or subwoofer
Rear SP:FULL
, you can con-
Rear SP:S.W
).
is selected), you
Rear SP:FULL
or the
S.W Control:INT
.
Notes
• Even if you change this setting, there is no
output unless you switch the non fading out-
put (refer to page 28) or subwoofer output
(refer to page 27) in the audio menu on.
• If you change the subwoofer controller, sub-
woofer output and non fading output in the
audio menu return to the factory settings.
• Both rear speaker leads output and RCA rear
output are switched simultaneously in this
setting mode.
1 Press to select
FUNCTION
Press repeatedly until
FUNCTION
appears in the display.
2 Change the rear output setting with 5/∞.
Pressing 5/∞ will switch between
(full-range speaker) and
:FULL
(subwoofer) and that status will be displayed.
Notes
• When no subwoofer is connected to the rear
output, select
Rear SP:FULL
• When a subwoofer is connected to the rear
output, set for subwoofer
• When the rear output setting is
you cannot change the subwoofer controller.
3 Change the subwoofer controller with
2/3.
Pressing 2/3 will switch between
and
:INT S.W Control :EXT
be displayed.
.
SW
Rear SP
Rear SP
Rear SP :S.W
.
.
Rear SP:S.W
,
Rear SP:S.W
S.W Control
and that status will