Synchronize clock with RDS
You can synchronize time shown on the unit
with that on the RDS station.
1
Tune to a RDS radio station that transmits
time signals.
2
Press RDS for over 2 seconds.
» [CT SYNC] is displayed and the unit
reads RDS time automatically.
» If no time signal is received, [NO CT]
is displayed.
Note
•
The accuracy of the transmitted time depends on the
RDS station that transmits the time signal.
16
EN
6 Other features
Set alarm timer
This unit can be used as an alarm clock. You
can select DISC, USB, or FM TUNER as alarm
source.
Note
•
Make sure that you have set the time correctly.
1
In standby mode, press and hold TIMER
until [TIMER SET](timer set) scrolls on the
display.
» [SELECT SOURCE] (select source)
scrolls on the screen.
2
Press SOURCE repeatedly to select a
source: DISC, USB, or FM TUNER.
3
Press TIMER to confirm.
» The hour digits are displayed and begin
to blink.
4
Press
/
repeatedly to set hour, then
press TIMER again to confirm.
» The minute digits are displayed and
begin to blink.
5
Press
/
to set minute, then press
TIMER to confirm.
is displayed.
»
Activate/deactivate alarm timer
In standby mode, press TIMER repeatedly to
activate or deactivate timer.
» If timer is activated,
is displayed.