Site Wiring Fault Indicator - HP T700 series User Manual

Operation
continued
Item
5
6

Site Wiring Fault Indicator

The UPS T700 NA model features a Site Wiring Fault Indicator (1) located on the rear panel
of the UPS unit. The Site Wiring Fault Indicator illuminates if the ground wire connection
does not exist, or if the line and neutral wires are reversed in the line receptacle. This
indicator remains illuminated until the condition is resolved.
For information and procedures to follow if the Site Wiring Fault Indicator is illuminated,
refer to Chapter 5, "Troubleshooting."
Figure 2-2: Site Wiring Fault Indicator
2-2
HP CONFIDENTIAL Codename: Sherman7 Part Number: 215420-002 Last Saved On: 10/4/02 10:27 AM
Description
Test/Alarm Reset button
On/Standby button
CAUTION: The UPS operates in this condition, but does not provide proper noise and surge
protection.
Meaning/Function
Resets alarms or initiates self-tests.
Places the UPS in Standby mode (turns output load segments
off) or starts UPS powering the load.
1
HP Uninterruptible Power System T700 Models User Guide