Placing The Ups In Operate Mode - HP T700 series User Manual

Operation

Placing the UPS in Operate Mode

The UPS can be placed in Operate mode if either of the following conditions apply:
•
The UPS is powered up and in Standby mode (unit is plugged in, utility power is present,
and none of the front panel LEDs are illuminated).
•
The UPS is powered down and no utility power is available.
Press and hold the On/Standby button (2). The Utility LED (1) initially illuminates solid
green, then the UPS continues with a series of beeps and LED flashes. When the Utility LED
remains illuminated solid green, power is available at the UPS output receptacles.
IMPORTANT: If the UPS is running on battery power (no utility power is present), press and hold the
On/Standby button (2) until the audible alarm sounds.
Figure 2-3: Placing the UPS in Operate mode
2-4
HP CONFIDENTIAL Codename: Sherman7 Part Number: 215420-002 Last Saved On: 10/4/02 10:27 AM
1
2
HP Uninterruptible Power System T700 Models User Guide