HP Phoneline Gateway hn200p User Manual page 8

phoneline gateway
Crossover Switch
The Crossover Switch (X II) toggles the LAN Port between crossover mode (X) and
straight-through mode (II). Choose one of the following options:
When connecting the Gateway directly to a computer or to an uplink port via
❑
the LAN port, choose crossover.
When connecting any other configuration, choose straight-through.
❑
Power
You will connect the included AC Power Adapter to the Power port.
Reset button
To refresh Gateway connections and attempt to fix routing problems, very briefly
depress the Reset button with a paper clip or pencil tip.
If you have exhausted all troubleshooting options (see the troubleshooting section of
this user's guide) and continue to experience serious routing problems, depress the
Reset button for about five seconds to clear all of the Gateway data and restore the
factory default settings.
Warning:
actual IP addresses and what the Gateway expects them to be. You may be
forced to restart the entire system.
If the Gateway locks up, unplug the Power Adapter from the Gateway's Power Port
for 3 to 5 seconds (but not longer) and then plug it back in. Leaving the power off
for too long could result in the loss of network connections.
8
Resetting the Gateway may create conflicts between your PC's