Table of Contents
Advertisement
THE FUNCTION OF CONTROL PANEL
Press this switch to turn the power 'ON' or 'OFF'.
Operation and temporary stop is repeated as it is pressed. When you want to change program in
operating; Press the 'Start/Pause' button
'Start/Pause' button again.
A
B
If you press the dial 'B', you take the dial 'B' out automatically,
If you want to select the course, you turn the dial 'B' and each lamp in 'A' is lighted corresponding to
the course you select.
You can select the wash course you want and each lamp is turned on when that course is selected.
As this button is pressed, the wash course is selected by 'Main Wash' 'Pre Wash' 'Soak' 'Adding
10min' 'Adding 20min'
You can select the rinse time(s) you want and each lamp is turned on when that course is selected.
As this button is pressed, the rinse time(s) is selected by '1'
... ...
You can select the spin speed you want and corresponding lamp is turned on when that spin
speed is selected.
It can be used to pre-engage time for wash from 2 hr to 12 hrs.
(For the Anti-Allergy Course, it is possible to choose from 1:00 hrs to 12:00 hrs.
Use to curtail the full cycle time to about 10 min.
After you select the course, you press the 'Time Save' button, and 'Time Save' is lighted.
If you select the course as follows: 'Drum Drying', 'Quick 30','Anti-Allergy', 'Time Save' is not selected.
You can select the dry condition you want and corresponding lamp is turned on when that dry
condition is selected.
Use this function when you want to protect any accident occurring from handling of washer by a child.
During an operation of washer, press 'SPIN' and 'DRY' buttons simultaneously during 3 second.
If this mode will be set successfully, CHL and remain time will be showen on PCB board alternately.
In Child Lock mode, no button functions except Power button.
If you want to set this mode, press 'SPIN' and 'DRY' buttons simultaneously during 3 second.
And if you want to release this mode, press 'SPIN' and 'DRY' buttons simultaneously again during 3
second.
If you want to change to the desire program, while this mode is working;
1. Press 'SPIN' and 'DRY' buttons simultaneously again during 3 second.
2. Press the 'Start/Pause' button.
3. Select the desired program and press the
* The Child Lock will be cancelled when power is off.
If you want to open Door intensionally during operation, press the 'Start/Pause' button and press again
'Door unlock' button.
In this case,
temperature and draining water, also no button functions except Power button.
'5'
'Add Water'
'1'.
'Start/Pause' buttom again.
signal will be appeared on PCB board, then you can open Door after cooling insideTub
9
Select the program that you want to change
'Add Water'
Press the
'2'
'Add Water'
Change
the desired
program
Advertisement
Table of Contents
