When The Appliance Is Switched On 23; On The Appliance - Siemens SN26T295GB Operating Instructions Manual

... when the appliance is
switched on
The appliance does not start.
– The mains fuse has tripped.
– The appliance plug has not been
inserted.
– The appliance door has not been shut
properly.
... changing settings
A setting cannot be changed, a
programme starts.
– Wrong programme button pressed.
Terminate the programme (see chapter
entitled "Terminating the programme
(Reset)") and start all over again.
– You did not wait until programme
ended.

... on the appliance

Lower spray arm rotates sluggishly.
– Spray arm blocked.
The door is difficult to open. *
– Child-proof lock is activated. The
deactivation instructions are at the
back in the envelope.
* depending on model
Door cannot be closed.
– Door lock has been activated. To reset,
close the door with greater force.
Cover on the detergent dispenser cannot
be closed.
– Detergent dispenser overfilled or
mechanism blocked by sticky
detergent residue.
Detergent residue in the detergent
dispenser.
– Dispenser was damp when filled.
"Check water supply" display @ lights
up.
– Tap turned off.
– Water supply interrupted.
– Supply hose kinked.
– Filter in the water supply blocked.
– Switch off the appliance and pull
out the mains plug.
– Turn off the tap.
– Clean filter in the supply hose.
– Reconnect power supply.
– Turn on the tap.
– Switch on the appliance.
– Water is left in the appliance
at the end of the programme.
– ( : ) Waste water hose
is blocked or kinked.
Filters blocked.
– ( : ) Waste water pump blocked,
cover on the waste water pump
is not locked in position
(see Waste water pump).
– Filters blocked.
– The programme has not yet ended.
Wait until programme ends (digital
display indicates :
implement the "Reset" function.
Error code :
– Filters 1j are soiled or blocked.
Refill indicator for salt H and/or rinse-
aid P is not lit.
– Refill indicator/s switched off.
– Adequate salt/rinse-aid available.
Refill indicator for special salt H is lit.
– No salt.
Refill with special salt.
– Sensor does not detect salt tablets.
Use different special salt.
en
) or
23