About Water-Proof, Dust-Proof, And Shock-Proof Performance Of The Camcorder - Sony Handycam HDR-GW66E Operating Manual

About water-proof,
dust-proof, and shock-
proof performance of
the camcorder
This camcorder is equipped to be water-
proof, dust-proof and shock-proof.
Damage caused from misuse, abuse
or failure to properly maintain the
camcorder is not covered by the limited
warranty.
This camcorder is water-proof/dust-proof

equivalent to IEC60529 IP58. The camcorder is
operable up to a water depth of 10 m (33 feet)
for 60 minutes.
Do not subject the camcorder to pressurized

water, such as from a tap.
Do not use in hot springs.

Use the camcorder in the recommended

operating water temperature range of 0 °C to
40 °C (32 °F to 104 °F).
Meeting MIL-STD 810F Method 516.5-Shock

standards, this product has passed the required
tests when dropped from a height of 1.5 m
(5 feet) above a 5 cm (2 in.) -thick plywood
board (with the LCD screen closed, facing
toward the camcorder body) * .
Depending on use conditions and
*
circumstances, no guarantee is made
regarding damage to, malfunction of, or the
water-proof performance of this camcorder.
As for dust-proof/shock-proof performance,

there is no guarantee that the camcorder will
not become scratched or dented.
Sometimes water-proof performance is lost if

the camcorder is subjected to a strong shock
such as from being dropped. We recommend
the camcorder be inspected at an authorized
repair shop for a fee.
Accessories supplied do not meet water-proof,

dust-proof, and shock-proof specifications.
Notes before using the camcorder
under/near water
Make sure that no foreign matter such as sand,

hair, or dirt gets inside the battery/memory
card/jack cover. Even a small amount of
foreign matter may lead to water entering the
camcorder.
Confirm that the sealing gasket and its mating

surfaces have not become scratched. Even a
small scratch may lead to water entering the
camcorder. If the sealing gasket or its mating
surfaces become scratched, take the camcorder
to an authorized repair shop to have the sealing
gasket replaced for a fee.
 Sealing gasket
 The sealing surfaces of the sealing gasket
If dirt or sand gets on the sealing gasket or its

mating surfaces, wipe the area clean with a
soft cloth that will not leave behind any fibers.
Prevent the sealing gasket from becoming
scratched by touching it while charging a
battery or using a cable.
Do not open/close the battery/memory

card/jack cover with wet or sandy hands or near
water. There is a risk this will lead to sand or
water getting inside. Before opening the cover,
perform the procedure described in "Cleaning
after using the camcorder under/near water".
Open the battery/memory card/jack cover with

the camcorder completely dry.
Always confirm that the battery/memory card/

jack cover has been securely locked.
GB