GE JVB94SHSS Dimensions

JVB94SH – GE Profile ™ 30" Telescopic Downdraft System
Overall Dimensions (in inches)
30
8-1/2
7-1/2
7-1/4
27
12-1/8
C L
14-3/8
30" Unit
17-7/8
28-3/8
Installation Information: Before installing, consult installation instructions
packed with product for current dimensional data.
Specification Revised 5/09
220963
Venting Options (in inches)
Through the Floor
2-1/4
In Cabinet Discharge (Right)
6-3/8
3-1/4
In Cabinet Discharge (Down) Note: Telescopic downdraft vents are not recommended to be installed
with cooktops that are flush mounted.
Approved for use with the following GE Profile ™ and GE cooktops –
36" and 30" electric models, 36" and 30" gas sealed burner models and
36" and 30" induction models.
Not approved for use with standard burner gas cooktops.
Note: The countertop must be at least 26" deep with a flat surface
area of 23-1/2" or more, front to back. In addition, other clearances
to the front edge of the countertop must be considered.
Note: Dimensions shown are for reference only. Before cutting out
countertop, refer to instructions packed with downdraft and cooktop.
In Cabinet Discharge (Left)
Note: Installation in cabinets/countertops against the wall
will not be possible in most applications. Against the wall
installations are limited to dimension requirements. Refer to
installation instructions packed with product for further details.
JXBC67 Outdoor Cover. Optional accessory may be ordered for
installation of motor and blower assembly on outside wall.
JXRB67 Indoor Remote Accessory. Optional accessory may be
ordered for installation of motor and blower assembly in an indoor
remote location.
Installation Information: Before installing, consult installation
instructions packed with product for current dimensional data.
For answers to your Monogram, ® GE Profile ™
or
GE ® appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center ® service, 800.626.2000.
Listed by
Underwriters
Laboratories