Installing Memory Module - Toshiba Satellite P30 User Manual

Before you install or remove a memory module, turn off the computer
with the Shut Down option in the Windows Start menu. If you install or
remove a memory module while the computer is in Standby or
Hibernation mode, data will be lost.
Some memory modules can be physically installed but are not
compatible with the computer. In this case the computer will issue a
warning.
Satellite P30 series: There will be a long beep, 3 short beeps, 3 more
short beeps and then a long beep when you turn the power on. In this
case, shut down the power and remove the incompatible memory
module.
CAUTION: If you want to upgrade system memory, you should only use
certified modules. Ask your vendor or check the TOSHIBA web site for
a list of approved memory products.

Installing memory module

If you use the computer for a long time, the memory modules will become
hot. In this case, let the memory modules cool to room temperature before
you replace them.
Follow these steps to install a memory module:
1. Set the computer to boot mode and turn off the power.
Do not try to install or remove a memory module under the following
conditions. You can damage the computer and the module.
a. The computer is turned on.
b. The computer was shut down using the Standby mode or
c. Power to the optical media drive has been turned on by the CD Power
2. Remove all cables connected to the computer.
3. Turn the computer upside down and remove the battery (refer to Chapter
6,
4. Remove the three screws securing the memory module socket cover.
5. Slide your fingernail or a thin object under the cover and lift it off.
Satellite P30
Hibernation mode.
switch.
Power and Power-Up Modes
).
Optional Devices
8-9