Table of Contents
Advertisement
C2
Appears in combination with BLOCKED DRAIN and indicates drain-
Iine is completely clogged. See page 6, BLOCKED DRAIN and C2.
C3
Appears when the dishwasher will not go into a drain-out period.
.
Dishwasher will not operate. CALL FOR SERVICE.
C4
Appears when there is too much water in the dishwasher. Turn off
water line to dishwasher before unlatching doo~ CALL FOR SERVICE.
Unless water is in tub after P~ then push START and CLEAR/RESET.
C6
C7
If
there is no water in the dishwasher at the time of a drain out period,
the cycle stops and C5 is displayed. Check that water line to
dishwasher is not turned off. If water line is not at fault CALL FOR
SERVICE.
Amears if water does not reach desired temperature for good
washability within the 20-minutes extended heating period. Water
heater may be out; or dishwasher may have been used too soon after
laundry or family baths.
Water heater thermostat may be set too low. Check water temperature
according to instructions on page 10. Reset water heater and try
another dishwashing cycle. If water temperature is correctly set at
water heater and C6 appears consistently CALL FOR SERVICE. There
may be a fault in the dishwasher's heater.
Indicates that temperature sensing device is defective. Dishwasher
will not heat water. CALL FOR SERVICE.
NOTE: If control panel doesn't respond to inputs, shut off power from dishwasher at fuse or circuit
breaker. Wait 5 seconds and restore power. Try inputs again.
.-4
Advertisement
Table of Contents
