Table of Contents
Advertisement
The SYSTEMS MONITOR tells you if something's wrong
, CUP OPEN
BLOCKED DRAIN
BLOCKED DRAIN and C2
SEE DOOR LABEL
Appears when power to dishwasher is interrupted. See if dishes are
dirty or if water is standing in tub. To pump water out of tub, push
START then CLEAR/RESET or overfill can occur. Replace detergent, if
missing.
Reset controls
and repeat cycle, if necessary. If there has
been a POWER FAILURE, your last settings will be erased and your
dishwasher will automatically program NORMAL WASH and
HEATED DRYING.
Appears after START pad is touched if detergent cup is not closed
properly. Unlatch doo~ add detergent to cup if it has been spilled,
close cup and relatch door. If cup is latched properly and CUP OPEN
display still appears, you may start wash cycle by pressing START
pad a second time. CALL FOR SERVICE, but dishwasher may
continue in use.
When BLOCKED DRAIN appears after cycle is completed, dishwasher
has a partial restriction and is taking too long to drain. Clean the air
gap. (See page 16.) If BLOCKED DRAIN still appears, try another
cycle. If situation is not corrected CALL FOR SERVICE.
When BLOCKED DRAIN appears and dishwasher is stopped and will
not drain; drain line is completely clogged. Clean the air gap. To get
dishwasher to pump out, start any cycle and then push CLEAR/
RESET If air gap is not at fault, CALL FOR SERVICE.
Appears in the SYSTEMS MONITOR with any of the above word
signals or any of the following fault codes. Door label gives brief
summary of instructions shown here.
("'
"w
r,
+-
Advertisement
Table of Contents
