GE PROFILE PDE9900 Technical Service Manual page 9

Ge dishwasher user manual
Table of Contents

Advertisement

5
Start
PDW8900 Series
Close the dishwasher door and select the cycle and desired enhancements. Touch the START/RESET pad to begin the
cycle. Water fill begins immediately, and approximately 60 seconds later the wash action begins.
When the dishwasher door is fully closed, the control panel lights will display the last settings you selected. If you don't
want to change any of the settings, simply touch the START/RESET pad to begin the cycle.
If the door is closed, the indicator lights will turn off if the START/RESET pad is not selected within 5 minutes. To activate
the display, open and close the door or press any pad.
PDW9700 and PDW9900 Series
After selecting the cycle and desired enhancements, touch the START/RESET pad to ready the dishwasher to begin the
cycle. Close the door to start the cycle or begin the DELAY START countdown. When the cycle starts, the water fill
begins and approximately 60 seconds later the wash action begins.
The dishwasher will always display your last selection and enhancements. If you don't want to change the settings,
simply touch the START/RESET pad to ready the dishwasher and close the door to begin the cycle.
Also, if a power failure occurs NORMAL and HEATED DRY will automatically be programmed. Make any new selections
and touch the START/RESET pad to begin the new cycle.
If the door is opened, the indicator lights will turn off if the START/RESET pad is not selected within 5 minutes.
To activate the display, open and close the door or touch any pad.
6
Clean
PDW8900 Series
The CLEAN light is illuminated when the selected cycle and enhancements are complete. The light will stay ON until
a pad is pressed or the door is opened and then closed.
PDW9700 and PDW9900 Series
The CLEAN light is illuminated and a double beep will sound when the selected cycle and enhancements are complete.
You may remove the dishes at any time. Note the high-efficiency fan will run quietly for 30 minutes to 4 hours (depending
on selected cycle) after the CLEAN light is illuminated to continue drying the dishes. The fan can be turned off by opening
the door and pressing any keypad.
NOTE: To turn off the audible end-of-cycle signal (or re-activate it if it was previously disengaged), press the HEATED
DRY pad 5 times within 3 seconds. A triple beep will sound to indicate the end-of-cycle beep option has been toggled.
NOTE: If you are not using the SmartDispense and you want to turn the LOW DETERGENT LED light off, press the
ADDED HEAT pad 5 times within 3 seconds. You will hear three beeps, then the light will go off. You can turn the light
back on by pressing the ADDED HEAT pad 5 times within 3 seconds.
– 9 –

Advertisement

Table of Contents
loading

Table of Contents