Download Print this page

GE 206C1559P148 Installation Instructions Manual

General electric built-in dishwasher installation instructions
Hide thumbs

Advertisement

Quick Links

Installation
Instructions

BEFORE YOU BEGIN

Read these instructions completely and
carefully .
IMPOR T ANT
governing codes and ordinances.
Note to Installer – Be sure to leave these instructions
for the
and local inspector
Note to Consumer Keep these instructions with your
Owner`s Manual for future reference.
Installation of this dishwasher requires
Skill level —
basic mechanical
,Plumbing
installation is the responsibility of the installer .
Product failure due to improper installation is not
covered under the
Dishwasher Warranty
Completion Time ? 1 to 3 Hours. New installations
require more time than replacement installations.
Observe all
Inspector s ' use.
and electrical skills. Proper
Built-In
Dishwasher
IMPORT ANT
MUST be installed to allow for future removal from
the enclosure if service is required.
If you received a damaged dishwasher , you should
immediately contact your dealer or builder .

FOR YOUR SAFETY

Read and observe all CAUTIONS and WARNINGS
shown throughout these instructions. While performing
installations described in this booklet, gloves, safety
glasses or goggles should be worn.
W ARNING
To reduce the risk of electrical shock, fire,
or injury to persons, the installer must
ensure that the dishwasher is completely
enclosed at the time of installation.
READ CAREFULLY.
KEEP THESE
INSTRUCTIONS.
206C1559P148 31-30207
The dishwasher
03-10 FL

Advertisement

loading

  Related Manuals for GE 206C1559P148

  Summary of Contents for GE 206C1559P148

  • Page 1: Before You Begin

    The dishwasher MUST be installed to allow for future removal from the enclosure if service is required. If you received a damaged dishwasher , you should immediately contact your dealer or builder . FOR YOUR SAFETY Read and observe all CAUTIONS and WARNINGS shown throughout these instructions.
  • Page 2: Parts Supplied

    Installation Preparation PA RTS SUPPLIED: Two #8 Phillips flat head wood screws, 5/8" long to secure dishwasher to underside of countertop (in literature package). MA TERIALS YOU WILL NEED : Ferrule, compression nut and 90°Elbow (3/8"NPT external thread on one end, opposite end sized to fit water supply)
  • Page 3: Prepare Dishwasher

    32" minimum, high drain loop will result in improper draining of the dishwasher . The dishwasher must be installed so that drain hose is no more than 10 feet in length for proper drainage. The dishwasher must be fully enclosed on the top, sides and back, and must not support any part of the enclosure.
  • Page 4: Prepare Electrical Wiring

    NOTE: Power cords with plug must pass through a separate hole. Electrical Connection to Dishwasher Electrical connection is on the right front of dishwasher . For cable direct connections the cable must be routed as shown in Figure 5. Cable must extend a minimum of 24"...
  • Page 5: Installation Instructions

    (Optional, but strongly recom- mended and may be required by local codes.) Water connection is on the left side of the dishwasher . Install the hot water inlet line, using no less than 3/8" O.D. copper tubing. Route the line as shown in Figure F and extend forward at least 18"...
  • Page 12: Step 16 Dishwasher Wet Test

    Reposition the dishwasher if necessary.See step 9. The dishwasher will drain and turn off about 5 to 7 minutes after the first fill.Check dain lines.If leaks are found,turn power off at the breaker and correct plumbing as necessar y.Restore power ater corrections are made.See Step 12.