Prepare Dishwasher; Drain Requirements - GE 206C1559P148 Installation Instructions Manual

General electric built-in dishwasher installation instructions
Table of Contents

Advertisement

PREPARE DISHW ASHER
32-1/2to 35"
Underside of
Countertop
to Floor
Floor MUST
be Even with
Plumbing and Electric Service
Figure 1
Room Floor.
Must Enter Shaded Area
The rough cabinet opening must be at least 24" deep
and 23-5/8" To
Wide. The opening should be
24"
to 35" max. height.

DRAIN REQUIREMENTS

Follow local codes and ordinances.
Do not exceed 10 feet distance to drain.
Do not connect
drain lines from other devices
to the dishwasher drain hose.
Dishwasher must be connected to waste line with an
air gap (not supplied) or 32" minimum high drain loop,
depending on local codes and ordinances to prevent
back flow into the dishwasher .
?Air gap must be used if waste tee or disposer connec-
tion is less than 18" above the floor to prevent siphoning.
DRAIN PREPARATION
The type of drain installation depends on answers to
the following questions:
Do local codes or ordinances require an air gap?
Will waste tee or disposer connection be less than
18" above the floor?
Will installation have a drain loop less than 32"
above floor?
If the answer to ANY of the 3 questions above is YES,
Method 1 MUST be used . Otherwise either Method 1
or Method 2 may be used. Figure 3 or Figure 4.
CAUTION:
An air gap MUST BE USED if the drain hose is connected
to waste tee or disposer lower than 18" above the floor.
Failure to provide the proper drain connection height
with air gap or 32" minimum, high drain loop will result
in improper draining of the dishwasher .
Installation Preparation
ENCLOSURE
24"
CLEARANCES: When
Min.
installed into a corner ,
4
allow 2" min. clearance
between dishwasher and
Cabinets
adjacent cabinet, wall or
Square
other appliances. Allow
6
and
25-5/8" min. clearance
Plumb
from the front of the
dishwasher for door
opening. Figure 2
Note:
tops may
leveling legs.
Method 1 Air Gap with Waste Tee or Disposer
Method 2 High Drain with Waste Tee or Disposer
Provide a method to attach drain hose to underside
of countertop.
Install waste tee or disposer and air gap according to
Manufacturer s ' instructions.
manufacturer
CABINET PREPARATION
·
3
The dishwasher must be installed so that drain hose is
no more than 10 feet in length for proper drainage.
The dishwasher must be fully enclosed on the top,
sides and back, and must not support any part of the
enclosure.
Llation,
(32-1/2")
by
Figure 3
32"
18"
18"
Min.
Min.
Min.
Figure 4
Drill a 1-1/2 dia.Hole in the cabinet wall within the
shaded areas shown in Figure 1 for the drain hose
connection. The hole should be smooth with no sharp
edges.
Countertop
Dishwasher
25-5/8"
Clearance for Door
Opening 2" Minimum
Figure 2
counter
the
and
32"
Min.
18"
Min.

Advertisement

Table of Contents
loading

Table of Contents