Unloading a Cartridge
The cartridge can be removed from the SDX-400V either in response to a
SCSI Unload Command, or by pressing the EJECT bottom.
By pressing EJECT button, the tape goes to BOT, the drive unthreads it,
and ejects the cartridge from the slot.
Write-protecting a Cartridge
Cartridges can be write-protected by sliding the tab on the back of the
cartridge. In this state, data can be read from the tape but not written onto it.
Using a Cleaning Cartridge
A cleaning function is built into the SDX-400V, so the use of a cleaning
cartridge is not needed. If however the drive experiences excessive errors,
the use of a cleaning cartridge is recommended.
Using your fingernail, push the switch in the
direction of the arrow to protect the tape from
writing or accidental erasure.
Return the switch to its original position to