Back Panel - NETGEAR N300 User Manual

Table 1. Front panel LED descriptions (continued)
LED Description
WPS • Solid green. Indicates that wireless security is enabled.
• Blinking green. The router is attempting to use WPS to add a wireless device or computer to
the wireless network.
• Blinking green rapidly for about 5 seconds. WPS has failed to add a wireless device or
computer.
• Blinking green rapidly and continuously. The router is in stuck in the temporary AP setup
locked state. For more information, see
page 125.
• Off. No WPS connection exists.

Back Panel

The back panel has the following buttons, ports, and connector:
Figure 3. Back panel
Table 2. Back panel button, port, and connector descriptions
Port or Button
WiFi On/Off button
Restore Factory Settings button Press and hold this button for about 7 seconds to reset the router to its
LAN ports
N300 Wireless Router WNR2000v4
The WPS (Push 'N' Connect) Button Blinks Amber
WiFi On/Off button
Restore Factory Settings button
LAN ports
Internet port
AC power connector
On/Off button
Description
Turns the wireless radio in the router on or off.
factory default settings.
Four local area network (LAN) 10/100 Mbps Ethernet ports for connecting the
router to your local computers.
Hardware Setup
10
on