Connecting A Decoder - Telefunken TTV32PF10 Operator's Manual

76 cm colour television
Table of Contents

Advertisement

Connecting a decoder

Via SCART
Make sure the TV and decoder are both
switched off.
Plug one end of the SCART lead (not
supplied) into the back of the decoder and the
other end into the SCART 1
on the back of the TV.
Switch on the decoder and the TV.
Press the AV button on the remote
AV
control to select AV1.
Via RCA lead
Make sure the TV and decoder are both
switched off.
Note: For Decoder connection Via RCA
lead your Decoder device should have the
tuner built in.
AV3/AV4
Plug one end of the RCA lead into the video
and audio out sockets on the back of the
decoder and plug the other end into the video
and audio in sockets on the TV.
Press the AV button repetitively and
select the AV3 mode (AV4 optional).
Please Note
You can record from one external device to
another via scart sockets. You should select
the source and destination of video using
FEATURES menu. If you select the source
as AV3/AV3-S or AV4/AV4-S (optional)
you will have a " WARNING: COPY
FUNCTION ACTIVE" message on the
screen. You will not have picture at
AV4/AV4-S if you select source
AV3/AV3-S or vice versa.
You can connect NTSC supported equipment
to the TV via the SCART sockets and
adjusting the colour via the PICTURE
menu.
Select TINT by using Program down
button and use to adjust the colour.
Volume up and down buttons.
R
AUDIO OUT
L
AV3
AV1
AV2
25

Advertisement

Table of Contents
loading

Table of Contents