Table of Contents
Advertisement
If you have a Sunfire or Carver system
equipped with Sonic Holography, then
it is recommended that you use a tape
measure to set the left and right loud-
speakers to be an equal distance away
from your listening position, within half
an inch tolerance. (Sonic Holography is a
unique process designed by Bob Carver
to enhance the three-dimensional effects
and realism of stereo sound.)
The Center Loudspeaker
Most movie dialog will come from the
center loudspeaker, so careful positioning
is an important part of a good home the-
ater system. Your eyes and ears should
focus your attention towards the center of
the display.
The CRW-C center loudspeaker can
above, or directly underneath the display,
as long as it is located on the centerline
and not off to one side.
Right
Center
Left
Sub
Center loudspeaker
If possible, have the center, left and
right loudspeakers at the same height
(within two feet). This will help give a
smooth transition when sound effects
move from loudspeaker to loudspeaker.
The CRM-BIP ribbon loudspeakers
may be used as surround loudspeakers,
as shown in the following systems and
illustrations.
Sunfire CRM-2BIP surround loudspeaker
User's Manual
5.1 Configuration
Place each surround loudspeaker an
equal distance away from your central
listening position, and keep them at least
one or two feet above ear level (with you
sitting down).
5.1 System
They can be placed either side of the
listening position.
6.1 and 7.1 Configuration
Sunfire home theater processors and
receivers have two extra outputs for sur-
round back loudspeakers. These create
a wonderful sense of realism in surround
effects during playback of Dolby Digital
EX, Dolby Pro Logic IIx, and DTS-ES.
Such systems can be configured for
one or two surround back loudspeakers.
If you are connecting one surround
back loudspeaker, place it directly behind
your listening position, with the surround
loudspeakers to the side as shown.
6.1 System
Right
Surround
Left
Surround
Surround
Back
9
Advertisement
Table of Contents
