Infrant Technologies ReadyNAS 1100 Getting Started Manual page 6

7
Set up ReadyNAS 1100
1
After powering up the unit, you will see the ReadyNAS system in the RAIDar scan list. When the Setup button becomes clickable, click Setup
to start the Setup Wizard. Use user name
Setup Button
2
After completing setup, your ReadyNAS is ready for use. (Refer to
A
RAID Configuration (Optional)
Your ReadyNAS 1100 comes in one of the following three configurations:
1
- Diskless system
- System with pre-installed disks in RAID 5 (Flexible Volume)
Follow the steps below to switch between RAID 0/1/5 Flexible Volume mode and the X-RAID
Expandable Volume mode only if you wish to change the above default configuration. (Please
note that it is not necessary to perform this procedure every time. The device will remain in the
selected mode until explicitly changed.)
2
Set RAID mode by performing a Factory Default.
Make sure ReadyNAS is connected to the network and RAIDar is running when performing the
Factory Default.
Factory Default will erase all your data on the hard disks.
admin and password infrant1 to login.
Quick Setup Guide
The Info column displays boot
and installation status, or the
OS version when ReadyNAS is
ready to use.
and Users Guide for setup details.)
RAID Configuration
Number
RAID RAID RAID
of disk
Installed
1
2
3
4
Legend: Redundancy against single disk of failure.
X-RAID auto volume expansion.
Storage capacity (base on single volumn configuration).
Default RAID setting.
X-RAID
0 1 5
p5