Hdmi Input; Sdi Input; Video Input - Panasonic PT-DZ870K Specification

TM
DLP Projector
Weights and dimensions shown are approximate. Specifications and appearance are subject to change without notice.
* 1 When the is set to
STANDBY MODE
cannot be used. Also, only certain commands can be received for external control using the serial terminal.
* 2 Measurement, measuring conditions, and method of notation all comply with ISO 21118 international standards.
* 3 Up to a total of ±55° during simultaneous horizontal and vertical correction.
* 4 Only compatible with dot clock frequency of 27 MHz (pixel repetition signal)
* 5 WUXGA resolution is supported only when the signals are compliant with VESA CVT-RB (Coordinated Video Timing-Reduced Blanking).
* 6 With legs at shortest position.
* 7 Average value. May differ depending on models.
* 8 The operating temperature range is 0 °C to 40 °C (32 °F to 104 °F) when the fan control is set to High Altitude mode (for altitudes from 1,400 m
to 2,700 m (4,593 ft to 8,858 ft) above sea level). Also, if the ambient temperature exceeds 40 °C (104 °F) (35 °C (95 °F) in High Altitude mode)
when the projector is being used with Lamp Select set to Dual and Lamp Power set to High, the light output may be reduced approximately
20% to protect the projector.
* 9 Operation range differs depending on environments.
Dimensions
Terminals
1 2 3 4
SDI IN VIDEO IN
8 9 10
As of September 2013
SFD13M004-2
PT-DZ870K/DZ870W/DZ870LK/DZ870LW
, network functions such as power on over the LAN network will not operate, and the serial output terminal
ECO
442 (13/32)
498 (19/32)
5 6 7
3D SYNC
IN/OUT OUT
DIGITAL LINK
11 12 13 14
unit : mm (inch)
NOTE: This illustration is not drawn to scale.
The illustration shows the PT-DZ870K/DZ870W.
432 (17)
1 Remote 1 input
2 Remote 1 output
3 Remote 2 input
4 Serial input
5 Serial output
6 3D sync 1 input/output
7 3D sync 2 output
8

SDI input

9

Video input

10 RGB 1 input
11 RGB 2 Input
12 DVI-D input
13

HDMI input

14 LAN/DIGITAL LINK connector
5 / 2 5