Signals; Guide - GE 2-9751 User Manual

H S
ANDSET
Signal
One beep every 7 seconds
Three long beeps (with ringer on)
A long warbling tone (with ringer on)
One long beep
T
ROUBLESHOOTING
In case of difficulty, please check the following Troubleshooting Guide
before seeking service.
Problem
No dial tone
12
S
OUND IGNALS
G
Solution
• Check installation:
— Is the base power cord connected to a working
outlet?
— Is the Phone-in-Use light on?
— Is the telephone line cord connected to the base
unit and the wall jack?
• Disconnect the base from the wall jack and connect
another phone to the same jack. If there is no dial tone
in the second phone, the problem might be your
wiring or local service.
• Is the handset out of range of the base?
• Make sure the battery is properly charged (12 hours).
• Is the battery pack installed correctly? See page 8.
• Did the handset beep when you pressed the phone
button? Did the Phone-in-Use light come on? The
battery may need to be charged.
Meaning
Battery is low
Page signal.
Signals an incoming call.
Handset and Base are
not communicating: the handset
might be too far away from the base,
you might need to try another
channel, or the base might not be
receiving power.
UIDE