Drive Address Setting; Default Setting - IBM DBCA-204860 - Travelstar 4.8 GB Hard Drive Specifications
( 3.2 / 4.8 / 6.4 gb ) 2.5-inch hard disk drive with ata interface
Hide thumbs
Also See for DBCA-204860 - Travelstar 4.8 GB Hard Drive:
- Quick installation manual (2 pages)
Table of Contents
Advertisement
6.6 Drive Address Setting
A jumper is available at the interface connector to determine the drive address. The set position of the
jumper is as shown in Figure 36.
Using Cable Selection, the drive address depends on the condition of pin 28 of the AT interface cable. In the
case when pin 28 is ground or low, the drive is a Master. If pin 28 is open or high level, the drive is a Slave.
Figure 36. Address setting by a jumper for DBCA-2xxxxx.
6.6.1 Default Setting
The default setting of jumper at shipment is No Jumper (Master).
50
O E M Specifications of DBCA-2xxxxx 2.5 inch H D D
Hide quick links:
Advertisement
Table of Contents
