IBM DBCA-204860 - Travelstar 4.8 GB Hard Drive Specifications page 74

A b o r t i n g H o s t i n t e r f a c e
A b o r t i n g D e v i c e o p e r a t i o n
I n i t i a l i z a t i o n o f h a r d w a r e
I n t e r n a l d i a g n o s t i c
S p i n n i n g s p i n d l e
I n i t i a l i z a t i o n o f r e g i s t e r s
D A S P h a n d s h a k e
P D I A G h a n d s h a k e
R e v e r t i n g p r o g r a m m e d p a r a m e t e r s t o d e f a u l t
N u m b e r o f C H S
( s e t b y I n i t i a l i z e D e v i c e P a r a m e t e r )
M u l t i p l e m o d e
W r i t e c a c h e
R e a d l o o k a h e a d
E C C b y t e s
V o l a t i l e m a x a d d r e s s
A d d r e s s o f f s e t m o d e
D i s a b l e S t a n d b y t i m e r
P o w e r m o d e
R e s e t S t a n d b y t i m e r v a l u e
o e x e c u t e
x n o t e x e c u t e
Figure 45. Reset Response Table
Note.
(*1) Execute after the data in write cache has been written.
(*2) Default value on P O R is shown in Figure 46 on page 67.
(*3) The Set Features command with Feature register = CCh enables the device to revert these
parameters to the power on defaults.
(*4) In the case of sleep mode, the device goes to idle mode.
change current mode.
(*5) After reset the Standby timer value, it is set to 109 minutes.
(*6) According to the initial power mode selection.
66
O E M Specifications of DBCA-2xxxxx 2.5 inch H D D
P O R
o
o
( * 6 )
( * 2 ) o
o
o
o
o
( * 6 )
( * 5 ) o
h a r d s o f t
r e s e t r e s e t
o o
( * 1 ) ( * 1 )
o x
o x
x x
o o
o x
o o
o ( * 3 )
o x
( * 4 ) ( * 4 )
o x
In other case, the device does not