7.0 Electrical interface specification
7.1 Cabling
The maximum cable length from the host system to the hard disk drive plus circuit pattern length in the host system
shall not exceed 18 inches.
7.2 Interface connector
The signal connector for AT attachment is designed to mate with Dupont part number 69764-044 or equivalent.
The figure below and Figure 2: "Mounting hole locations" on page 29 show the connector and pin location.
Figure 1: Interface connector pin assignments
Pin position 20 is left blank for correct connector insertion.
Pin positions A, B, C, and D are used for the drive address setting. (Refer to Figure 4 : "Drive address setting" on
page 51 for correct address setting.)
43
22
44
Pin
Figure 3 : Interface connector pin assignments
Travelstar 5K80 Hard Disk Drive Specification
Pin
1
19
C
2
D
35
A
B