Table of Contents
Advertisement
11.0 General
11.1 Reset response
ATA has the following three types of resets:
Power On Reset (POR)
Hard Reset (Hardware Reset) The RESET signal is negated in the ATA Bus. The device resets the interface
Soft Reset (Software Reset)
The actions of each reset are shown in the table below.
Table 43: Reset response table
Aborting Host interface
Aborting Device operation
Initialization of hardware
Internal diagnostic
Starting spindle motor
Initialization of registers (*2)
DASP- handshake
PDIAG- handshake
Reverting programmed parameters to default
Number of CHS (set by Initialize Device Parameters)
Multiple mode
Write Cache
Read look-ahead
ECC bytes
Volatile max address
Address offset mode
Power mode
Reset Standby timer value (*5)
o – execute
Notes:
(*1)
Execute after the data in write cache has been written.
(*2)
The default value on POR is shown in Table 44: "Default Register Values" on page 66.
(*3)
The Set Features command with Feature register = CCh enables the device to revert these parameters
to the power on defaults.
(*4)
In the case of sleep mode, the device goes to standby mode. In other cases, the device does not
change current mode.
(*5)
After reset the Standby timer value is set to 109 minutes.
(*6)
Set according to the initial power mode selection.
The device executes a series of electrical circuitry diagnostics, spins up the
head disk assembly, tests speed and other mechanical parametric, and sets
default values.
circuitry and sets the default values.
The SRST bit in the Device Control Register is set and then is reset. The device
resets the interface circuitry according to the Set Features requirement.
x – does not execute
Travelstar 5K80 Hard Disk Drive Specification
POR
hard reset
-
-
o
o
(*6)
o
o
o
o
(*6)
o
65
soft reset
o
o
(*1)
(*1)
x
x
x
x
x
x
o
o
o
x
o
o
o
(*3)
(*4)
(*4)
o
o
Hide quick links:
Advertisement
Table of Contents
