Hitachi HDT725025VLA380 - Deskstar 0A33423 T7K500 250GB SATA 7200RPM 8MB Cache Hard Drive Specifications page 60

Notes:
1. To enable the CSEL mode (Cable Selection mode) the jumper block must be installed at E-F. In the CSEL
mode the drive address is determined by AT interface signal #28 CSEL as follows:
• When CSEL is grounded or at a low level, the drive address is 0 (Device 0).
• When CSEL is open or at a high level, the drive address is 1 (Device 1).
2. In CSEL mode, installing or removing the jumper blocks at A-B or C-D position does not affect any selec-
tion of Device or Cable Selection mode.
7.1.4.2 15 logical head default
The figure below shows the jumper positions used to select Device 0, Device 1, Cable Selection, or Device1
(Slave) Present setting 15 logical heads instead of default 16 logical head models.
Notes:
1. To enable the CSEL mode (Cable Selection mode) the jumper block must be installed at E-F. In the CSEL
mode the drive address is determined by AT interface signal #28 CSEL as follows:
• When CSEL is grounded or at a low level, the drive address is 0 (Device 0).
• When CSEL is open or at a high level, the drive address is 1 (Device 1).
2. In CSEL mode, installing or removing the jumper blocks at A-B or C-D position does not affect any selec-
tion of Device or Cable Selection mode.
I G E C A
H F D B
I G E C A
H F D B
I G E C A
H F D B
I G E C A
H F D B
Deskstar T7K500 Hard Disk Drive Specification
DEVICE 0 (Master)
DEVICE 1 (Slave)
CABLE SEL
DEVICE 1 (Slave) Present
46