Hitachi HDT725025VLA380 - Deskstar 0A33423 T7K500 250GB SATA 7200RPM 8MB Cache Hard Drive Specifications page 282

Input Parameters From The Device
Sector Number (HOB=0)
Sector Number (HOB=1)
Cylinder Low (HOB=0)
Cylinder Low (HOB=1)
Cylinder High (HOB=0)
Cylinder High (HOB=1)
CCTO (Error, bit 0)
SE (Status, bit 5)
DWE (Status, bit 4)
LBA (7:0) of the address of the first unrecoverable error.
LBA (31:24) of the address of the first unrecoverable error.
LBA (15:8) of the address of the first unrecoverable error.
LBA (39:32) of the address of the first unrecoverable error.
LBA (23:16) of the address of the first unrecoverable error.
LBA (47:40) of the address of the first unrecoverable error.
CCTO bit shall be set to one if a Command Completion Time Limit Out error has
occurred.
SE (Stream Error) shall be set to one if an error has occurred during the execution
of the command and the WC bit is set to one, In this case the LBA returned in the
Sector Number registers shall be the address of the first sector in error, and the
Sector Count registers shall contain the number of consecutive sectors that may
contain errors. If the WC bit is set to one when the command is issued and an
IDNF, ABRT, or CCTO error occurs, the SE bit shall be set to one, the ERR bit
shall be cleared to zero, and the bits that would normally be set in the Error
register shall be set in the error log.
DWE (Deferred Write Error) shall be set to one if an error was detected in a
deferred write to the media. This error is from a previously issued command. If
DWE is set to one, the location of the deferred error is only reported in the Write
Stream error log.
Deskstar T7K500 Hard Disk Drive Specification
268