About The Remote Control Unit; Inserting The Batteries; Operating Range Of The Remote Control Unit - Denon DCD-CX3 Operating Instructions Manual

ENGLISH

About the remote control unit

Inserting the batteries

q Remove the remote control w Set two R03/AAA batteries in
unit's rear cover.
e Put the rear cover back on.
Notes on batteries:
• Replace the batteries with new ones if the set does not operate
even when the remote control unit is operated close to the unit.
(The supplied batteries are only for verifying operation.)
• When inserting the batteries, be sure to do so in the proper
direction, following the "q" and "w" marks in the battery
compartment.
• To prevent damage or leakage of battery fluid:
• Do not use a new battery together with an old one.
• Do not use two different types of batteries.
• Do not attempt to charge dry batteries.
• Do not short-circuit, disassemble, heat or dispose of batteries in
flames.
• If the battery fluid should leak, carefully wipe the fluid off the
inside of the battery compartment and insert new batteries.
• Remove the batteries from the remote control unit if it will not be
in use for long periods.

Operating range of the remote control unit

• Point the remote control unit at the remote sensor when operating
it.
• The remote control unit can be used from a distance of up to about
8 meters, at a horizontal angle of up to 30° with respect to the
sensor.
the battery compartment in
the indicated direction.
Approx. 8 m
NOTE:
• The set may function improperly or the remote control unit may
not operate if the remote control sensor is exposed to direct
sunlight, strong artificial light from an inverter type fluorescent
lamp or infrared light.
30°
30°

ENGLISH