Ford Super Duty Owner's Manual page 375

Hide thumbs Also See for Super Duty:

Table of Contents

replacing an inboard rear tire on dual rear wheel vehicles, the valve stem

must be facing outward. If replacing the outboard wheel, the valve stem

must be facing inward. Reinstall the lug nuts until the wheel is snug against

the hub. Do not fully tighten the lug nuts until the wheel has been lowered.

10. Lower the wheel by turning the jack handle counterclockwise.

Go to Step 19.

The following steps apply to F–350 Dual Rear Wheel (DRW) and

F–450/F–550 vehicles only:

2013 F-250/350/450/550 (f23)

Owners Guide gf, 1st Printing

Wheels and Tires

7. Turn the jack handle clockwise

until the wheel is completely off the

ground and high enough to install

the spare tire.

8. Remove the lug nuts with the lug

9. Replace the flat tire with the spare

tire, making sure the valve stem is

facing outward for all front wheels

and single rear wheel vehicles. If

11. Slide the notched end of the

jack handle over the release valve

and use the handle to slide the jack

under the vehicle. Make sure the

valve is closed by turning it

12. Position the jack according to

the following guides:

• Front (4x2): F–350 DRW

Note: Place the jack directly under