Events - Axis Q1765–LE User Manual

AXIS Q1765–LE Network Camera

Events

Events
The Axis product can be configured to perform actions when different events occur, for example, start a recording when motion is
detected. The set of conditions that defines how and when the action is triggered is called an Action Rule.
Available Action Rule triggers and conditions include:
• Applications — use installed applications to trigger the rule, see Applications, on page 34.
• Detectors
- Audio Detection — trigger the rule when audio is detected, see Audio Detection, on page 33.
- Day/Night Mode — trigger the rule when the product switches between day mode (IR cut filter on) and night
mode (IR cut filter off). This can for example be used to control an external infrared (IR) light connected
to an output port.
- Live Stream Accessed — trigger the rule when any stream is accessed and during edge storage playback.
This can for example be used to send notifications.
- Motion Detection — trigger the rule when motion is detected, see Motion Detection, on page 31.
- Tampering — trigger the rule when tampering is detected, see Camera Tampering, on page 31.
• Hardware
- Network — trigger the rule if network connection is lost or restored. This can for example be used to start
recording to the SD card.
- Temperature — trigger the rule if the temperature falls outside or inside the operating range of the product. This
can for example be used to send maintenance notifications.
• Input Signal
Digital Input Port — trigger the rule when an I/O port receives a signal from a connected device, see I/O
-
Ports, on page 51.
Manual Trigger — trigger the rule using the Manual Trigger button in the Live View page, see Controls on
-
the Live View Page, on page 10. This can for example be used to validate actions during product installation
and configuration.
- Virtual Inputs — can be used by a VMS (Video Management System) to trigger actions. Virtual inputs can, for
example, be connected to buttons in the VMS user interface.
• PTZ
Error — trigger the rule if the PTZ functionality is not working correctly. This can for example be used to
-
send maintenance notifications.
Moving — trigger the rule when the camera view moves due to a PTZ operation. This can for example be used
-
as an additional condition to prevent an action rule triggered by motion detection to record video while the
camera view moves due to a PTZ operation.
- Preset Reached — trigger the rule when the camera stops at a preset position. This can be for example be used
with the Send Images action to upload images from the preset position.
- Ready — trigger the rule when the PTZ functionality is ready to be used. This can for example be used to steer
the camera to a specific preset position when the product is started.
• Storage
36