Assembly - Weslo Cadence Dl15 User Manual

ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Refer to the drawings below to identify the small
parts used in assembly. Assembly requires your own phillips screwdriver
wrenches , and scissors
1. Note that the Right Handrail and the Console Base
are connected to the treadmill by a Wire Harness
(not shown). During steps 1 through 5, be careful
not to pull on or damage the Wire Harness.
With the help of a second person, carefully lay the
treadmill on its side. Position one of the Base Legs
(38) on the base of the Upright (31) as shown. Make
sure that the Base Leg Pads (41) and the Front
Wheel (39) are in the indicated positions. Attach the
Base Leg with two 3/8" x 2" Bolts (43), two 3/8"
Washers (44), and two 3/8" Nuts (34).
Carefully turn the treadmill onto its other side.
Assemble the other Base Leg (38) as described.
With the help of a second person, carefully raise the
treadmill to the upright position so the Base Legs
(38) are resting flat on the floor.
2. Refer to HOW TO LOWER THE TREADMILL FOR
USE on page 11. Follow the instructions in step 2 to
lower the treadmill.
Attach the Storage Latch (18) to the left Upright (31)
with two Screws (24). Be careful not to overtight-
en the Screws.
3. Cut the plastic ties that hold the cage nuts in each
Handrail (30, 32).
Position the Left Handrail (30) on the left Upright
(31). Thread a 1/4" x 1" Bolt (23) with a 1/4" Washer
(22) only two turns into the upper end of the left
Upright and the Left Handrail. Do not tighten the
Bolt yet.
Thread a 1/4" x 1" Bolt (23) with a 1/4" Washer (22)
only two turns into the lower end of the Left Handrail
(30) and the left Upright (31). Do not tighten the
Bolt yet.
.
1
31
2
3
5
, two adjustable
43
39
44
41
34
38
31
24
18
23
22
31
23
22
30