Weslo Cadence 50 Ls User Manual page 8

DIAGRAM OF THE CONSOLE
Speed Control
Note: If there is a thin sheet of clear
plastic on the console, remove it.
CAUTION:
console, read the following precautions.
• Do not stand on the walking belt when turn-
ing on the power.
• Always wear the clip (see the drawing
above) whilst operating the treadmill. When
the key is removed from the console, the
walking belt will stop.
• Adjust the speed in small increments.
• To reduce the possibility of electric shock,
keep the console dry. Avoid spilling liquids
on the console and use only a sealable
water bottle.
STEP-BY-STEP CONSOLE OPERATION
Make sure that there are batteries in the console (see
assembly step 6 on page 6). In addition, make sure
that the power cord is properly plugged in (see page
7). Next, step onto the foot rails of the treadmill. Find
the clip attached to the key (see the drawing above),
and slide the clip onto the waistband of your clothes.
Test the clip by carefully taking a few steps back-
ward until the key is pulled from the console. If the
key is not pulled from the console, adjust the posi-
tion of the clip as needed.
Key
Before operating the
Monitor Displays
Mode
Button
Follow the steps on this page and page 9 to operate
the console.
Insert the key fully into the console.
1
Inserting the key will not turn on the two displays.
The displays will turn on when the ON/RESET but-
ton is pressed or when the walking belt is started.
If you just installed batteries, the displays will
already be on.
Reset the console and start the walking belt.
2
Slide the speed con-
trol to the RESET
position. Note: Each
time the walking belt
is stopped, the
speed control must
be moved to the
RESET position before the walking belt can be
restarted.
Next, slowly slide the speed control to the right
until the walking belt begins to move at slow
speed. Carefully step onto the walking belt and
begin exercising. Change the speed of the walk-
ing belt as desired by sliding the speed control.
To stop the walking belt, step onto the foot rails
and slide the speed control to the RESET position.
8
Pulse
Clip Sensor