Maintenance And Troubleshooting - Weslo Cadence 150 Treadmill User Manual

MAINTENANCE AND TROUBLESHOOTING

Most problems can be solved by following the simple steps below. If further assistance is needed,
please call our Customer Service Department.
1. SYMPTOM: THE CONSOLE DOES NOT
FUNCTION PROPERLY
a. Replace the batteries in the console (see assem-
bly step 5 on page 5).
b. Make sure that the reed switch is properly adjust-
ed (see assembly step 3 on page 4).
c. Make sure that the handrail wire is plugged fully
into the wire on the console (see assembly step 6
on page 5).
d. The console, like most electronics, is susceptible
to static electricity build-up caused by certain
types of clothing or by the operation of the tread-
mill. If the display is blank or gives incorrect read-
ings, apply an anti-static spray to the handrail.
Anti-static spray is available where laundry sup-
plies are sold.
2. SYMPTOM: THE WALKING BELT DOES NOT
MOVE SMOOTHLY
a. If the walk-
ing belt is
overtight-
ened, per-
formance
may be
reduced and
the walking
belt may be
permanently
damaged.
Using the
hex key,
turn both rear roller adjustment bolts counter-
clockwise 1/4 of a turn. When the tension of the
walking belt is correct, you should be able to lift
each side of the walking belt 5 to 7 cm (2 to 3 in.).
Walk on the treadmill for a few minutes. Repeat
until the walking belt is properly tightened. Be
careful to keep the walking belt centred.
Walking
Belt
5–7 cm
Bolts
3. SYMPTOM: THE WALKING BELT SLIPS OR IS
OFF-CENTRE
a. If the walking
belt slips
when walked
on, use the
hex key to turn
both adjust-
ment bolts
clockwise, 1/4
of a turn. When the walking belt is correctly tight-
ened, you should be able to lift each side of the
walking belt 5 to 7 cm (2 to 3 in.). Walk on the
treadmill for a few minutes. Repeat until the walk-
ing belt is properly tightened. Be careful to keep
the walking belt centred.
b. If the walking
belt has shift-
ed to the left
side, use the
hex key to turn
the left adjust-
ment bolt
clockwise, and
the right adjustment bolt counterclockwise, 1/4 of
a turn each. Be careful not to overtighten the
walking belt. Walk on the treadmill for a few min-
utes. Repeat until the walking belt is centred.
c. If the walking
belt has shift-
ed to the right
side, use the
hex key to turn
the left adjust-
ment bolt coun-
terclockwise,
and the right adjustment bolt clockwise, 1/4 of a
turn each. Be careful not to overtighten the walk-
ing belt. Walk on the treadmill for a few minutes.
Repeat until the walking belt is centred.
8