Table of Contents
Advertisement
HOW TO OPERATE THE TREADMILL
HOW TO ADJUST THE RESISTANCE
To increase the intensity of your workout, you can adjust the resistance on the
walking belt. To increase the resistance, turn the Resistance Knob (44) clockwise.
To decrease the resistance, turn the Resistance Knob counterclockwise.
MAINTENANCE AND TROUBLESHOOTING
IMost problems can be solved by following the simple steps below. If further assistance is needed,
please call our Customer Service Department.
1. SYMPTOM: THE CONSOLE DOES NOT
FUNCTION PROPERLY
a. Replace the batteries in the console (see
assembly step 5 on page 5).
b. Make sure that the reed switch is properly
adjusted (see assembly step 3 on page 4).
c. Make sure that the handrail wire is plugged fully
into the wire on the console (see assembly step 6
on page 5).
d. The console, like most electronics, is susceptible
to static electricity build-up caused by certain
types of clothing or by the operation of the treadmill.
If the display is blank or gives incorrect readings,
apply an anti-static spray to the handrail. Anti-static
spray is available where laundry supplies
are sold.
2. SYMPTOM: THE WALKING BELT DOES NOT
MOVE SMOOTHLY
a. If the walking belt
is overtightened,
performance may
be reduced and the
walking belt may
be permanently
damaged. Using the
hex key,turn both rear
roller adjustment bolts
counterclockwise 1/4 of a turn. When the tension of
the walking belt is correct, you should be able to lift
each side of the walking belt 5 to 7 cm (2 to 3 in.).
Walk on the treadmill for a few minutes. Repeat until
the walking belt is properly tightened. Be careful to
keep the walking belt centred.
Courroie
mobile
5–7 cm
Boulons
3. SYMPTOM: THE WALKING BELT SLIPS OR IS
OFF-CENTRE
a. If the walking belt slips
when walked on, use the hex
key to turn both adjustment
bolts clockwise, 1/4 of a turn.
When the walking belt is
correctly tightened, you should
be able to lift each side of the walking belt 5 to 7 cm
(2 to 3 in.). Walk on the treadmill for a few minutes.
Repeat until the walking belt is properly tightened.
Be careful to keep the walking belt centred.
b. If the walking belt has
shifted to the left side, use
the hex key to turn the left
adjustment bolt clockwise,
and the right adjustment bolt
counterclockwise, 1/4 of a turn
each. Be careful not to overtighten the
walking belt. Walk on the treadmill for a few minutes.
Repeat until the walking belt is centred.
5–7 cm
c. If the walking belt has shifted
5–7 cm
to the right side, use the hex
key to turn the left adjustment
bolt counterclockwise, and
5–7 cm
the right adjustment bolt
clockwise, 1/4 of a turn each.
Be careful not to overtighten
the walking belt. Walk on the treadmill for a few
minutes. Repeat until the walking belt is centred.
7
59
Advertisement
Table of Contents
