Fiat 500 Abarth User Manual page 27

There is no voice training required for using voice
commands with this system.
To issue a voice command to the system, press the
steering wheel button and wait for the radio to mute,
then listen for "Say a command" and then a tone indi-
cating that voice recognition is active. Then, speak the
command in your natural voice at a moderate pace.
When the system recognizes the command, it will ac-
knowledge your command by speaking a response or
acting on your command.
Voice commands are organized according to three in-
creasing levels: 1st level, 2nd level and 3rd level.
When a valid* 1st level keyword is said, the system will
activate 2nd level keywords; when a valid 2nd level
keyword is said, the system will activate 3rd level
keywords.
If the user says a valid 1st level keyword, then the
submenu relevant to that command will remain active
until a keyword leading to another level is given, the
interaction is interrupted or the system times out because
no command has been given; the same rule applies for
the other lower levels (2nd and 3rd level).
NOTE: For the list of available keywords, refer to
VOICE COMMANDS (KEYWORDS) - SUMMARY.
* Valid means that the keyword said is included in the
BLUE&ME™ "dictionary" and can therefore be recog-
nized by the system for the concerned level.
To repeat the last system voice announcement, press the
steering wheel button and say "Repeat" or hold
the steering wheel down for longer than 1 second.
The system can issue voice announcements. A voice
announcement is a spoken message initiated by the
system. To cancel a voice announcement, press the
BLUE&ME™ User's Manual 25
1