Fuel Cap; Tire Pressure Monitoring System (Tpms); Oil Change Indicator - Chrysler Aspen Quick Reference Manual

V
e h I c l e

Fuel Cap

LOOSE gAS cAP MESSAgE
if a "gas cap" odometer message (shown as gAScAP) appears,
•
tighten the gas cap until a "clicking" sound is heard.
Press the odometer reset button to turn the message off.
•
if the message continues to appear for more than three days after
•
tightening the gas cap, see your dealer.

Tire Pressure Monitoring System (TPMS)

if one or more of the four road tire pressures are low, the Tire
•
Pressure Monitoring Light will illuminate and an audible chime
will sound.
check the inflation pressure of each road tire on your vehicle and
•
inflate to the recommended cold pressure value, shown on the
placard located in the driver's door opening. The TPMS display
should not be used as a tire pressure gauge when adjusting your
tire pressure.
The light will turn off once the updated tire pressure has been
•
recognized. The vehicle may need to be driven for up to
10 minutes above 15 mph (25 km/h) before the light will turn off.
Temperature changes can affect tire pressures causing the
•
TPMS light to turn on. colder temperatures will decrease tire
pressure and warmer temperatures will increase tire pressure.
if a spare tire is in use on the vehicle, the TPMS light may turn on.
•
refer to your Owner's Manual.

Oil Change Indicator

MESSAgE
if an "oil change" message (shown as cHAngE Oil or Oil change
•
required) appears and a single chime sounds, it is time for your
next required oil change.
rESETTing LigHT AfTEr SErvicing
Turn the ignition switch to the On/rUn position
•
(do not start engine).
fully depress the accelerator pedal three times within 10 seconds.
•
Turn the ignition switch to the Off/LOck position.
•
F
e at u