Table of Contents
Advertisement
step 3
AC mains lead connection
Except [Australia]and[N.Z.]
Before connecting the AC mains lead
Set the voltage.
Use a flat-head screwdriver to move
VOLT ADJ
the voltage selector to the appropriate
position for the area in which this
110 127V
220 240V
system is used.
Conserving power
The main unit consumes a small amount of power, even when it is in
standby mode (approx. 0.2 W). To save power when the unit is not to be
used for a long time, unplug it from the household mains socket.
You will need to reset some memory items after plugging in the main
unit.
step 4
Preparing the remote control
Batteries
Insert so the poles ( and ) match those in the remote control.
R6/LR6, AA
Replace the cover.
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace only
with the same or equivalent type recommended by the manufacturer.
Dispose of used batteries according to the manufacturer's instructions.
≥ Use alkaline or manganese batteries.
≥ Do not heat or expose to flame.
≥ Do not leave the battery(ies) in an automobile exposed to direct
sunlight for a long period of time with doors and windows closed.
8
AC mains lead (included)
Press in and lift up.
Main unit
AC IN
To household mains socket
[Note]
The included AC mains lead is for use with the main unit only.
Do not use it with other equipment. Also, do not use cords for other
equipment with the main unit.
Do not:
≥ mix old and new batteries.
≥ use different types of batteries at the same time.
≥ take apart or short circuit.
≥ attempt to recharge alkaline or manganese batteries.
≥ use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage which can
severely damage the remote control.
Remove the batteries if the remote control is not going to be used for a
long period of time. Store in a cool, dark place.
Use
Aim at the remote control signal sensor (
maximum range of 7 m directly in front of the unit.
35), avoiding obstacles, at a
Hide quick links:
Advertisement
Table of Contents
