Internet Access Setup - ZyXEL Communications P-660HU-Tx Quick Start Quide

1. DSL: Use a telephone wire to connect your P-660HU-Tx's DSL port
to a telephone jack (or to a splitter, if one is already installed).
2. LAN: Use an Ethernet cable to connect a computer to a LAN port for
initial configuration and/or Internet access.
3. POWER: Use the power adaptor provided with your P-660HU-Tx to
connect an appropriate power source to the POWER socket. Make
sure the power source is on.
4. Push the ON/OFF button to the ON position. Look at the lights on the
front panel.
• The POWER light blinks while your P-660HU-Tx starts up and
stays on once it is ready. The DSL light is on when the P-660HU-Tx
has a DSL connection. The INTERNET light is on when you are
able to access the Internet and blinks when the P-660HU-Tx is
sending or receiving data.
• Each LAN light stays on if the corresponding LAN port is properly
connected and blinks when there is traffic.
If any of these lights are not on, check your connections, and inspect
your cables for damage. If the lights are still off, contact your local
vendor.

Internet Access Setup

The DSL and INTERNET lights are on if you have internet access. Open
your web browser and browse to www.zyxel.com. You may be prompted
to enter your username and password.
P-660HU-Tx
5