Related Manuals for ZyXEL Communications P-660HU-Tx
Summary of Contents for ZyXEL Communications P-660HU-Tx
- Page 1 P-660HU-Tx ADSL2+ 4-port Gateway with Firmware v1.02 Edition 1, 10/2011 DEFAULT LOGIN DETAILS IP Address: http://192.168.1.1 User: admin Password: 1234 Copyright 2011 ZyXEL Communications Corporation www.zyxel.com...
- Page 2 Device Panels ON/OFF RESET BUTTON INTERNET POWER USB PORT LAN1-4 LAN PORT 1-4 POWER DSL PORT...
-
Page 3: Package Contents
P-660HU-Tx Overview The P-660HU-Tx (x stands for 1 or 3) is an ADSL router with a four-port built-in Ethernet switch. The P-660HU-Tx allows wired clients to safely access the Internet. Package Contents ADSL Router RJ45 1.5M LAN Cable Power Adapter Quick Start Guide RJ11 1.5 Phone Cable... -
Page 4: Hardware Connections
Hardware Connections This section shows you how to set up your P-660HU-Tx. Warning: Remove any clear plastic covers from the P-660HU-Tx before using it. Also, do not use the device outside, and make sure all the connections are indoors. There is a remote risk of electric... -
Page 5: Internet Access Setup
• The POWER light blinks while your P-660HU-Tx starts up and stays on once it is ready. The DSL light is on when the P-660HU-Tx has a DSL connection. The INTERNET light is on when you are able to access the Internet and blinks when the P-660HU-Tx is sending or receiving data. -
Page 6: The Web Configurator
If one or both of these lights are not on, try turning the P-660HU-Tx off, check the connections, wait a few seconds and then turn it back on. If the DSL light is not on, contact your service provider. If the DSL light is on but the INTERNET light is not, you need to enter your Internet access configuration using the Web Configurator - see page 6. - Page 7 P-660HU-Tx 3. The following screen displays if you have not yet changed your password. It is strongly recommended you change the default password. Enter a new password, retype it to confirm and click Apply; alternatively click Ignore to proceed to the main menu if you do not want to change the password now.
- Page 8 5. Click INTERNET SETUP. Wait while your P-660HU-Tx tries to detect your DSL connection. 6. Follow the directions in the wizard. Enter the settings as specified by your ISP. For more details on using the wizard for Internet configuration, see Internet and Wireless Wizard Setup in the User’s...
-
Page 9: Troubleshooting
• To configure the Internet connection, go to Network > WAN See the User’s Guide for configuration procedures on these features and others on the P-660HU-Tx. Troubleshooting Warning: Do NOT open the device or unit. ONLY qualified service personnel should service or disassemble this device. - Page 10 LAN port, follow these steps. a. Check the lights on the front panel. If they are different from what is described on page 5, make sure the P-660HU-Tx is correctly connected. If the lights are still different, turn off the device, wait a few seconds, and turn it on again.