Programming Sb26 To Respond To Your Tv Remote - Harman Kardon SB26 Owner's Manual

SB26

Programming SB26 to Respond to Your TV Remote

you can program the SB26 to make it respond to your tV remote's power, mute, volume
up and volume down commands. this programming lets you control power and volume
functions of your SB26 soundbar with your tV remote. Before beginning to program
the SB26, have your tV remote in hand. we recommend sitting down in front of
the soundbar.
NOTE: Some steps will time out, so read through this entire process before
you begin.
have the tV remote in hand. when you start programming the remote, be ready to
aim the tV remote to the front of the soundbar from about 300 mm – 900 mm
(about 12 – 36 inches) away.
30 mm (12'')
tv remote
to program the power, surround, volume down, volume up and mute commands:
1. ensure that the SB26 is On.
2. On the soundbar, press and hold the soundbar's Surround button
until the visible Surround button flashes amber. If the button does
not flash after three seconds, release the buttons and try again.
Hold down the button until the
surround button indicator flashes
Programming SB26 to respond to your tV remote
3. you have to press the soundbar button that you want to program (Power,
Volume down, Volume up, Volume down and up simultaneously for Mute).
Momentarily press the button
you want to program
4. you have to aim the tV remote at the front of the soundbar and
slowly press the corresponding button on the remote until the
Surround button on the soundbar flashes white for one second. this
indicates that the programming operation has been successful.
5. to exit the learning mode (at any time or when the learning
is complete), press and hold the soundbar surround button
until the amber illumination stops flashing.
NOTE: If you would like to program a new TV remote control or you are
missing a command, restart the whole process.
If you would like to cancel the learning, reset the SB26. Put the SB26 in Standby mode,
press and hold the Surround and Volume – button simultaneously. Once factory
defaults are restored, the SB26 surround button will flash white for one second, then
the unit will enter into operational mode.
12