Adjusting The Quick-Release Axle - Invacare 9000 Standard Weight User Manual

8 REAR WHEELS
8.2

Adjusting the Quick-Release Axle

WARNING
Never use quick-release axles on recliner wheelchairs.
1. Remove rear wheel and quick-release axle from the wheelchair. Refer to Removing/Installing Rear Wheels on page 48.
2. Depress detent pin in the quick-release axle and slide axle through the rear wheel hub.
3. Release detent pin ensuring that the detent balls are fully released.
4. Increase or decrease end play by adjusting the locknut on the end
of the quick-release axle.
WARNING
Make sure the detent pin and detent balls of the
quick-release axle are fully released before operating the
wheelchair.
Keep detent balls clean.
5. Reinstall rear wheel onto the wheelchair. Refer to
Removing/Installing Rear Wheels on page 48
Invacare® Jymni™ Pediatric Series Wheelchair
.
50
Wheelchair Frame
Locking Pins
Axle Spacer
Quick-Release Axle
FIGURE 3 Adjusting the Quick-Release Axle
Locknut
Detent
Pin
Rear Wheel
Hub
Part No 1100868