Adjusting Quick-Release Axle; Installing Quad-Release Axle - Invacare A4 Owner's Operator And Maintenance Manual

WHEELS
ADJUSTING QUICK-RELEASE AXLE (FIGURE 2)
1. Remove rear wheel and quick-release axle from the wheelchair.
2. Depress detent pin in the quick-release axle and slide axle through the wheel hub.
3. Release detent pin ensuring that the
locking pins are fully released.
4. Increase or decrease end play by
adjusting the locknut on the end of the
quick-release axle.
WARNING
Make sure the detent pin and
locking pins of the quick-release
axle are fully released BEFORE
operating the wheelchair.
Keep locking pins clean.
5. Reinstall rear wheel onto the
wheelchair.
INSTALLING QUAD-RELEASE AXLE (FIGURE 3)
1. Remove rear wheel and existing
quick-release axle from wheelchair.
2. Remove EXISTING quick-release axle
from rear wheel hub.
3. Insert NEW quad-release axle through
rear wheel hub.
4. Slide locking collar onto quad-release
axle until it is snug against rear wheel and
tighten securely with allen screw.
5. Reinstall rear wheel and the quad-
release axle onto the wheelchair.
Make sure the detent pin and locking pins of the quad-release axle are
fully released BEFORE operating the wheelchair.
Keep locking pins clean.
6. Flip handle of quad-release axle down to release detent pin ensuring that locking
pins are fully released.
7. If detent pin does not fully release, proceed to ADJUSTING THE QUAD-RELEASE
HANDLE IN AND/OR OUT in this section of the manual.
8. Repeat STEPS 1-7 for the opposite rear wheel.
Part No. 1110545
Camber Bushing
Locking
Pins
Quick- Release Axle
Wheel Hub
NOTE: End of Quick-Release axle is shown for
reference only. It is not visible when inserted
into camber bar.
FIGURE 2 - ADJUSTING
QUICK-RELEASE AXLE
Quad-Release Axle
Rear Wheel Hub
NOTE: End of Quad-Release axle is shown for
reference only. It is not visible when inserted
into camber bar.
FIGURE 3 - INSTALLING
QUAD-RELEASE AXLE
WARNING
45
SECTION 5
Locknut
Detent Pin
Allen Screw
Camber Bushing
Locking Collar
A4™AND A4™TITANIUM