Invacare 9000 Standard Weight User Manual page 49

Quick-Release Axles
WARNING
NEVER use quick-release axles on the recliner.

If replacing the same size rear wheel, note the mounting position on the wheelchair frame for proper reinstallation of the new rear wheel.
1. Push the detent pin in the tip of the quick-release axle (with wheel) and pull the axle out through the opening in the center of the rear wheel and axle spacer.
2. Push the detent pin in the tip of the quick-release axle again and pull
the axle out of the rear wheel.
3. Repeat STEPS 1-2 for the opposite rear wheel.
4. To reinstall the rear wheel onto the wheelchair, reverse STEPS 1-3.
WARNING
Make sure the detent pin and detent balls of the
quick-release axle are fully released before operating the
wheelchair.
The detent balls MUST be protruding past the inside of
the rear wheel axle bushing for a positive lock (Detail
"A").
Keep detent balls clean.
Invacare recommends inserting quick-release axles with
the detent pin to the inside of the wheelchair to prevent
accidental release during contact activities.
5. If the detent balls are not protruding past the inside of the axle bushing
or there is too much side-to-side movement of the rear wheel assembly,
refer to Adjusting the Quick-Release Axle on page 50.
Part No 1100868
Detail "A" - Detent balls and detent pin
Axle Bushing
Inside of
Wheelchair
Detent Balls
Quick-Release Axle
Axle Mounting Positions
Rear Wheel
Quick Release Axle
FIGURE 2 Removing/Installing Rear Wheels - Quick-Release Axles
49
Invacare® Jymni™ Pediatric Series Wheelchair
8 REAR WHEELS
Outside of
Wheelchair
Detent Pin
Wheelchair Frame
Axle Spacer