Invacare 9000 Standard Weight User Manual page 55

Installing Anti-Tippers
 To ensure the correct model anti-tipper is used refer to the Anti-tipper Identification Chart below. Measurements for anti-tippers are
approximate and are taken with extension tube in top hole position Detail "A".
REAR WHEEL SIZE
20 inch
22 inch
1. Depress the release buttons and insert the anti-tippers with the
anti-tipper wheels pointing toward the ground/floor into the
wheelchair frame tubing as shown in FIGURE 1.
2. Measure the distance between the bottom of the anti-tipper wheels
and the ground/floor.
 A 1½ to 2-inch clearance between the bottom of the
anti-tipper wheels and the ground/floor MUST be
maintained at all times.
3. If the distance between the bottom of anti-tipper wheels and the
ground/floor is not 1½ to 2-inches, adjust anti-tippers. Refer to
Adjusting Anti-Tippers on page 56.
4. If necessary, reverse STEPS 1-2 to remove the anti-tippers.
Part No 1100868
ANTI-TIPPER LENGTH
9 inches
9-5/8 inches
55
ANTI-TIPPER PART NUMBER
1101959
1058752
Anti-Tipper
Wheels
Anti-Tipper
Release Buttons
Detail "A"
Anti-Tippers
FIGURE 1 Installing Anti-Tippers
Invacare® Jymni™ Pediatric Series Wheelchair
10 ANTI-TIPPERS/WHEEL LOCKS
Anti-Rattle
Rear Frame
Tubing
Top Position
Anti-Tipper
Length