Loadingand using the dryer.
Always follow the fabric manufacturer's care label when laundering.
Sorting and Loading Hints
As a general rule, if clothes are sorted properly for the
washer,theg are sorted properly for the drgeE
Do not add fabric softener sheetsonce the load has
become warm. They may cause fabric softener stains.
Bounce®Fabric Conditioner Dryer Sheetshove been
approved for use in all GEDryers when used in
accordance with the manufacturer's instructions.
Do not overload. This wastes energy and causes
Do not dry the following items: fiberglass items,
woolens, rubber-coated items, plastics,items with
plastic trim and foam-filled items.
Care and Cleaning of the Dryer
The Exterior: Wipe or dust any spills or washing
compounds with a damp cloth. Dryer control
panel and finishes may be damaged by some
laundry pretreatment soil and stain remover products.
Apply these products awag from the dryeEThe fabric
may then be washed and dried normally. Damage to
your dryer caused bg these products is not covered
by gour warranty.
The Lint Filter: Cleanthe lint filter before each
use. Moisten your fingers and reach into the filter
opening. Run your fingers acrossthe filten Havea
qualifiedtechnician vacuum the lint from the dryer
once a gear
Stainless Steel: To clean stainless steel surfaces,
use a damp cloth with a mild, non-abrasive cleaner
suitable for stainless steel surfaces. Remove the
cleaner residue, and then drg with a clean cloth.
The Exhaust Duct: Inspect and clean the exhaust
ducting at least once a gear to prevent clogging.
A partially clogged exhaust can lengthen the
Follow these steps:
IT] Turn off electrical supply bg disconnecting the
plug from the wall socket.
F_ Disconnect the duct from the dryer
F_ Vacuum the duct with the hose attachment and
reconnect the duct.
TheExhaust Hood: Checkfrom the outside that the
flaps of the hood move freely when operating. Hake
sure that there is not wildlife (birds,insects,etc.)nesting
insidethe duct or hood.