Confirming Multiview Cables Are Detected - 3Dlabs WILDCAT REALIZM 800 User Manual

To configure Multiview
1. Insert one end of the Multiview cable (included in your Wildcat Realizm Multiview
Option Kit) into the Multiview Out port of the first workstation. This workstation
becomes the "Master"
2. Insert the other end of the cable into the Multiview In port of the second
workstation. This workstation becomes a "Slave."
3. If connecting more than two workstations, continue linking workstations to one
another by connecting the Multiview Out port of one workstation to the Multiview In
port of the next. The last workstation should only have a cable plugged into the
Multiview In port. No external termination is required for the last workstation as this
is provided by the Multiview hardware.

Confirming Multiview cables are detected

1. Click the desktop with your right mouse button (or left-click if you've changed your default
mouse setup) to access the Display Control Panel.
2. Select Properties from the menu that appears.
3. Choose the Settings tab.
4. Click the Advanced button and then select the 3Dlabs tab.
5. Click the Displays icon on the left, then click "Advanced."
6. Under the "Genlocking/Multiview" tab (default tab) and under Genlocking/Multiview Status,
you'll see either Master or Slave (depending on which workstation you are viewing) listed
after "Multiview Cable." If you see "Not Detected," then check to make sure your Multiview
cable is seated firmly in the Multiview In port.
3Dlabs Wildcat Realizm Graphics Accelerator User's Guide
36
A A
PPENDIX